Emulsion-Powered Hydraulic Pump

Driven by the Face Emulsion Main

The Emulsion-Powered Hydraulic Pump is built for the longwall face, where emulsion mains already run to the hydraulic supports. The pump carries an emulsion motor fed from that line, which pressurizes its own hydraulic oil to 63 MPa to drive destressing jacks and chain cutters. No separate cable or air hose is brought out to the corner.

Because the face already has emulsion pipework spread end to end, the crew plugs in and works; the company notes this emulsion-to-ultra-high-pressure technology is offered by few domestic makers. The pump takes 10-32 MPa inlet emulsion and delivers 2.0 L/min at 63 MPa. It runs on emulsion or hydraulic oil as the drive medium, and internal parts are anti-rust with emulsion-resistant seals.

The unit weighs 18 kg and carries its own 4.0 L oil tank, so the driven tool still uses hydraulic oil and is not corroded by emulsion. Its compact size fits a toolbox or hangs on a rib, and the company reports long-running face customers who have used it for two years without major issues.

MOQ is one unit. It is the standard power choice for corner destressing and face chain cutting. The company notes this emulsion-to-hydraulic boost technology is offered by few domestic makers, and it reports face customers who have run the pump for two years without major issues. The tool it drives still runs on clean hydraulic oil from the 4 L tank, so emulsion does not corrode the tool internals. The face emulsion main runs at roughly 20-30 MPa to feed the supports, and the booster takes that in at 10-32 MPa to deliver 63 MPa at 2.0 L/min. Anti-rust internals and emulsion-resistant seals suit the wet, dripping face. The compact body fits a toolbox or hangs on a rib next to the destressing jack or chain cutter.

Hot Tags: emulsion-powered hydraulic pump, China emulsion-powered hydraulic pump manufacturers, suppliers, factory, Emulsion Powered Hydraulic Pump, hydraulic power supply, , Pneumatic Hydraulic Pump