Mining Chain Cutter

A Tool For Cutting Round Link Chains

The chain cutter has three parts: the cutter frame, the cylinder, and the blades. It needs a pump to work. We recommend our pneumatic, manual, or electric pump. The cutter uses a double-blade structure. Two blades move from both sides toward the middle. The cut is clean and fast. Many coal mines need to cut worn chains. In the past, they used hammers. Hammers take forever. Our chain cutter solves this. Our company started in 2007. We have 20 patents. We serve large clients like China Coal Group.

Our blades are made with military technology. They are for high-hardness materials like round link chains. The blade edge is specially heat-treated. It is very hard. Cutting a 42 mm high-strength chain is easy. We tested on 42 mm chains. After 50 cuts, the blade had no visible damage. This technology is leading in China. The Mining Chain Cutter uses a double-blade cutting method. Two blades move at the same time from both sides. The advantage is a clean cut. The chain cross-section does not deform. So the remaining chain link can still be used. With single-blade cutting, the chain gets flattened. The blade opening is large. You can put the chain in sideways. You do not need to remove the chain. You can operate it right on the conveyor pan. One action cuts one chain link. Efficiency is high.

The table below gives the data for the Mining Chain Cutter. We offer a 12-month warranty. The MOQ is one set. Delivery for standard products takes 1-2 days.